Cover Garage Conversion ADU: The Mesquite Owner’s Guide
A Cover-compatible garage conversion ADU in Mesquite typically runs $48,000 to $95,000 before permit fees for the enclosed, conditioned living space, and scheduling is planned rather than same-day because a conversion involves permits, inspections, and trade work. Most Mesquite owners find out their conversion is failing the same way: a hairline crack opens across the slab-to-wall joint, the garage side of a shared wall starts reading 5 to 10 degrees warmer than the house, or a door that closed clean in January drags on the frame by July. Those are not cosmetic gripes in Clark County. They are the first visible symptoms of thermal movement, moisture, and settling in a space that was never engineered to be lived in. We install and correct Cover-compatible garage conversions built by the book, and we work alongside owners who already studied the Cover catalog and want the build to match it.
Which Cover Models This Applies To

Cover builds modular units in distinct product lines and sizes, and the garage conversion work we do is not a Cover factory part at all. It is the site work a conversion demands: slab moisture control, framing of the shared wall, insulation to Title 24 targets, electrical and HVAC tie-ins, and finish work that has to meet Clark County inspection. So “which Cover model” matters less than “which Cover model is going into which garage.”
How to identify what you actually have before calling anyone:
- Find the data plate. Cover units carry a label with the model and serial. Photograph it. That tells us the footprint, the wall assembly, and the utility stub locations.
- Measure the garage, not the unit. Clear interior width and depth, ceiling height to the bottom of the joist, and the position of the existing slab drain. A Cover unit can be spec-perfect and still not fit a Mesquite garage with a raised curb or a post-tension slab.
- Check the HOA packet. Many Mesquite subdivisions, especially the newer master-planned ones, have design review rules on exterior finish and roof pitch that override the catalog look.
On the OEM-versus-aftermarket question: for the structural and enclosure work there is no “OEM part.” There is the manufacturer’s spec sheet and a licensed crew who builds to it. We are an independent builder and are not affiliated with Cover; we build the conversion to their spec and to local code.
Signs Your Cover Garage Conversion ADU Is Failing
Garage conversions fail in a predictable order. Catching the symptom early usually means a repair in the hundreds or low thousands rather than a rebuild.
- A crack running along the wall-to-slab joint. The original garage slab was poured to carry a car, not a conditioned living space. When it does not have a proper moisture barrier or a floating floor assembly, thermal and moisture movement opens that joint. It is the first thing to check.
- The shared wall reads noticeably warmer than the house. If the garage-side surface is 5 to 10 degrees hotter in July than the interior wall of the main house, the insulation is undersized or was compressed during framing. In Mesquite’s summer, that gap shows up as a hot room and a high electric bill.
- Interior doors that drag or won’t latch. Wood and drywall move with humidity. A door that swings freely in winter and sticks in summer points to a missing vapor control layer or a framing member that is picking up moisture from the slab.
- Dusty, musty smell with no visible leak. Usually a failed seal at the garage door opening where the old door was removed and the wall was framed in. That transition is the hardest detail in a conversion and the most commonly rushed.
- Permit board or inspection history with a gap. If a prior crew left an inspection unclosed, you may be living in a space the county has not signed off on. That affects resale, insurance, and your ability to finance anything later.
Replacement Cost & What’s Included

Installed pricing for the work that turns a garage into a Cover-ready, code-compliant living space in Mesquite:
| Item | Typical range |
|---|---|
| Slab prep, moisture barrier, and floor assembly | $4,500 – $11,000 |
| Shared-wall framing, insulation, and drywall to Title 24 | $6,000 – $14,000 |
| Electrical panel work, circuits, and HVAC tie-in | $8,000 – $22,000 |
| Garage door opening infill and weather seal | $2,500 – $6,500 |
| Permits and inspections (Clark County / Mesquite) | $1,200 – $4,800 |
What drives the range: slab condition (post-tension versus conventional), whether the panel has capacity for a subpanel, and how far the unit sits from the main house for utility runs. You get the number in writing before any work starts. Our written one-year guarantee covers workmanship defects. If something fails inside that year, we come back and make it right at no charge.
If you are weighing a factory unit against a site-built addition, we also work with Abodu and Dvele, along with prefab and modular platforms including Mighty Buildings, Boxabl, and Plant Prefab, so we can tell you honestly whether the garage conversion or a backyard build fits your lot and budget better.
DIY or Call Us?
What you can safely do yourself: photograph the data plate, measure the garage clear dims, check the county permit history by address, and watch a hygrometer in the room for two weeks. Record the readings. That data is useful and free.
What you should not touch: the electrical panel tie-in, gas line work if the unit has any, and any structural alteration to the shared wall. Those carry real risk of fire, gas leak, or collapse and require a licensed trade and an inspection. We have seen homeowners open a wall to “check insulation” and cut clean through a post-tension cable. That is a five-figure mistake on a garage slab.
If you are unsure where your conversion sits, call (833) 717-0766. A free estimate tells you what you actually need.
FAQs

A properly built conversion should hold 25 to 40 years for the structural and enclosure work, with the finish layers and weather seals needing attention every 8 to 12 years. Mesquite’s dry heat and 40-plus-degree summer swings are hard on sealants and exterior paint, so the roof and door-opening seal want an inspection around year 8.
Usually yes for the seal, the floor assembly, and insulation, which is why we price the repair first and the rebuild only if the inspection warrants it. A slab joint that has been scribed and caulked repeatedly is different from a wall that was framed without a moisture barrier; the second rarely survives a patch.
A single failing component like a door seal or a section of shared-wall insulation can typically be corrected in one to three days once the part is on site. A full floor assembly rebuild runs one to two weeks, and any electrical or structural change waits on the Clark County inspection schedule.
For Cover-specific hardware and spec-matched components we order to the model and serial from your data plate, and for structural and envelope work we build to the manufacturer’s published spec using materials we name in the written quote. The cover page of that quote lists every line item and price. That has been how we have operated under The Garrison Standard since 2006.
Call (833) 717-0766 for a free estimate on your Cover-compatible garage conversion. We answer live, 24 hours a day, seven days a week, and we hand you the price in writing before any work starts.
Written by the team at Fielding ADU Builders Mesquite, serving Mesquite and nearby areas.











